Industrial gates for industrial and aviation hangars

Large industrial automatic roller gates AL-120 with reliable drive are installed for aviation, helicopter and production hangars. Here are examples of completed works.

Gates for unheated hangars and northern regions

Since hangars are often installed in the northern regions, and they are not heated, there is a problem of freezing and jamming of the canvas and the gate drive. The MBA manufacturing company has experience in installing large hangar gates in cold regions and unheated rooms. The roll-up structure of the gate is least susceptible to freezing with ice sticking. No snow clearing is required in front of the gate to open and close. Additional heating is installed for the drive and the engine. Reliable construction, quite strong and is not afraid even of severe frosts.

Wide gates for aircraft and helicopter hangars

Since the dimensions of even small aircraft reach 20-30 meters, there is a problem of overlapping wide openings. Openings 40-50 meters wide are required for entry into the repair hangar of medium-fuselage aircraft. Such openings cannot be heavily loaded and stationary racks cannot be made. Gates made of the AL120 profile can be made up to 12 meters wide with one canvas, and when using sliding truss racks, the width of the entire structure can be more than 40 meters. The racks roll to the side and do not take up much space. The canvas is wound into a roll and does not take up useful space.

Non-standard sizes and rooms

The design department of our company is constantly faced with non-standard openings, large sizes and special wishes of customers. In our catalog of completed works, there are options with different lifting heights of the gate leaf, stationary and folding gates in the design of roll gates. Each object is individually worked out, loads are calculated, the necessary color of the canvas is selected.

Types of gates for large hangar openings

Large openings are a rather specific order that only a few companies can make. Because of the sanctions, there are problems with the supply of foreign gates and their components, which means even fewer companies are ready to take on huge gates.

Of the known designs , there are large gates:

1. Sectional industrial gates, wide lamellas with insulation. The width of the gate is limited and usually does not exceed 8-9 meters. Installation requires considerable space under the ceiling.
   
   

2. Roll-up gates. They can be made with a width of more than 40 meters with sliding consoles and up to 12 meters with one canvas. The roll does not take up additional space in the room and before entering.
   

3. PVC double-layer lifting gates. They are quite rare due to the high cost. It is possible to overlap large hangar openings, but there is a possibility of damage to the PVC fabric. Additional space is required in the upper part of the opening to lift the canvas.

The cost of large hangar gates of any design is quite high and depends on many nuances of manufacturing and installation. No one will immediately tell the finished cost of the gate, preliminary measurements, drawing and calculation are required.